Front Axle Hub Bolt: Replacement

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are the LH side.

1. REMOVE FRONT WHEEL 
2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH  (See DISASSEMBLY )
3. REMOVE FRONT DISC  (See INSPECTION )
4. REMOVE FRONT AXLE HUB BOLT 
   1. Using SST, remove the hub bolt that needs to be replaced.

      SST 09650-17011 

      Fig 1: Removing Hub Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL FRONT AXLE HUB BOLT 
   1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
   2. Using a brass bar or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.
6. INSTALL FRONT DISC  (See REASSEMBLY )
7. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH  (See INSTALLATION )
8. INSTALL FRONT WHEEL 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

   Fig 2: Installing Front Axle Hub Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002