Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System >> TC and CG Terminal Circuit >> Inspection Procedure

Inspection Procedure

  1. CHECK WIRE HARNESS (DLC3 - ECM AND BODY GROUND) 
    1. Disconnect the A9 ECM connector.
    2. Measure the resistance of the wire harness side connectors.

      Standard resistance 

      for 2GR-FE 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      E13-13 (TC) - A9-16 (TC) Below 1 Ω
      E13-4 (CG) - Body ground

      for 2AR-FE 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      E13-13 (TC) - A9-7 (TC) Below 1 Ω
      E13-4 (CG) - Body ground

      NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

      Fig 1: Identifying Terminals Of A9 ECM Connector
      G05999543Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: REPLACE ECM 

scientia non olet · About Mike's Workshop Manuals