DTC P0575: Cruise Control Input Circuit: Procedure
WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- READ DTC OUTPUT
- Clear the DTCs. Refer to DTC CHECK / CLEAR .
- Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
- Drive the vehicle at a speed for which cruise control operation is possible.
- Turn the cruise control main switch (ON-OFF button) on.
- Push the -SET switch to activate the cruise control.
- Check the DTCs. Refer to DTC CHECK / CLEAR
.
OK
DTC is not output.
NG → See step 2
OK → See step 3
- REPLACE ECM. Refer to REMOVAL
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
- READ DTC OUTPUT
- Clear the DTCs. Refer to DTC CHECK / CLEAR .
- Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
- Drive the vehicle at a speed for which cruise control operation is possible.
- Turn the cruise control main switch (ON-OFF button) on.
- Push the -SET switch to activate the cruise control.
- Check the DTCs. Refer to DTC CHECK / CLEAR
.
OK
DTC is not output.
NG → See step 2
OK → See step 3
- REPLACE ECM. Refer to REMOVAL
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING