Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Highlander Base, 2.7 A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (1AR-FE) - Circuit Testing, Component Inspection, Removal & Installation >> Heated Oxygen Sensor >> Inspection

Heated Oxygen Sensor: Inspection

  1. INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
    1. Measure the resistance according to the value (s) in the table below.

      Standard Resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      1 (HT1B) - 2 (+B) 20°C (68°F) 11 to 16 Ω

      If the result is not as specified, replace the heated oxygen sensor.

      Fig 1: Identifying Heated Oxygen Sensor Connector
      G06111333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals