Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Highlander Base, 2.7 A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (1AR-FE) - Circuit Testing, Component Inspection, Removal & Installation >> Camshaft Position Sensor >> Removal

Camshaft Position Sensor: Removal

  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side) 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      Fig 1: Locating Bolt And Sensor
      G05997191Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side) 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
scientia non olet · About Mike's Workshop Manuals