Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Corolla Base, 1.8 L, Standard >> Repair and Diagnosis >> General Information >> OEM General Information >> Heating / Air Conditioning >> Blower Unit >> Reassembly

Blower Unit: Reassembly

  1. INSTALL BLOWER MOTOR SUB-ASSEMBLY 
    1. Install the blower motor sub-assembly with the 3 screws.
      Fig 1: Locating Blower Motor Sub-Assembly And Screws
      G06015453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL BLOWER RESISTOR 
    1. Install the blower resistor with the 2 screws.
      Fig 2: Locating Blower Resistor And Screws
      G06015452Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL CLEAN AIR FILTER 
    1. Install the clean air filter as shown in the illustration.
      Fig 3: Installing Clean Air Filter
      G06015456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL AIR FILTER CASE 
    1. Engage the 2 claws and install the air filter case as shown in the illustration.
      Fig 4: Identifying Air Filter Case And Claws
      G06015457Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL AIR INLET CONTROL SERVO MOTOR (for Manual Air Conditioning System) 
    1. Install the air inlet control servo motor with the 2 screws.
      Fig 5: Identifying Air Inlet Control Servo Motor And Screws
      G06015448Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL AIR INLET CONTROL SERVO MOTOR (for Automatic Air Conditioning System) 
    1. Install the air inlet control servo motor with the 2 screws.
      Fig 6: Identifying Air Inlet Control Servo Motor And Screws
      G06015449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals