Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Corolla Base, 1.8 L, Standard >> Repair and Diagnosis >> General Information >> OEM General Information >> Heating / Air Conditioning >> Blower Unit >> Disassembly

Blower Unit: Disassembly

  1. REMOVE AIR INLET CONTROL SERVO MOTOR (for Manual Air Conditioning System) 
    1. Remove the 2 screws and the air inlet control servo motor.
      Fig 1: Identifying Air Inlet Control Servo Motor And Screws
      G06015448Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE AIR INLET CONTROL SERVO MOTOR (for Automatic Air Conditioning System) 
    1. Remove the 2 screws and the air inlet control servo motor.
      Fig 2: Identifying Air Inlet Control Servo Motor And Screws
      G06015449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE AIR FILTER CASE 
    1. Disengage the 2 claws and remove the air filter case as shown in the illustration.
      Fig 3: Identifying Air Filter Case And Claws
      G06015450Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE CLEAN AIR FILTER 
    1. Remove the clean air filter as shown in the illustration.
      Fig 4: Removing Clean Air Filter
      G06015451Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE BLOWER RESISTOR (for Manual Air Conditioning System) 
    1. Remove the 2 screws and the blower resistor.
      Fig 5: Locating Blower Resistor And Screws
      G06015452Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE BLOWER MOTOR SUB-ASSEMBLY 
    1. Remove the 3 screws and the blower motor sub-assembly.
      Fig 6: Locating Blower Motor Sub-Assembly And Screws
      G06015453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals