Inspection Procedure
NOTE:
When replacing the yaw rate and deceleration sensor, perform zero point calibration (See
CALIBRATION ).
- CHECK FOR DTC
- Clear the DTCs (See DTC CHECK/CLEAR ).
- Start and idle the engine for 60 seconds, and then stop the engine.
- Check if the same DTC is output (See DTC CHECK/CLEAR ).
Result
RESULT REFERENCEResult Proceed to DTCs (C1442/44 and/or C1443/34) are output A DTCs (C1442/44 and C1443/34) are not output B B: CHECK FOR INTERMITTENT PROBLEMS (See CHECK FOR INTERMITTENT PROBLEMS )
A: REPLACE YAW RATE AND DECELERATION SENSOR (See REMOVAL )