VVT Sensor: Installation

INSTALL VVT SENSOR (for Bank 2)
1. Apply a light coat of engine oil to the O-ring of the VVT sensor.
2. Install the VVT sensor with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
3. Connect the sensor connector.
  
  Fig 1: Locating VVT Sensor & Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the No. 4 and No. 5 water by-pass hoses.
  
  Fig 2: Locating Water By-Pass Hoses No. 4 & No. 5
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL VVT SENSOR (for Bank 1)
1. Apply a light coat of engine oil to the O-ring of the sensor.
2. Install the sensor with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
3. Connect the sensor connector.
INSTALL AIR CLEANER ASSEMBLY WITH ELEMENT . (See INSTALLATION ).
INSTALL NO. 2 AIR CLEANER HOSE . (See INSTALLATION ).

Fig 3: Locating Bolt & Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
ADD ENGINE COOLANT . (See REPLACEMENT ).
INSPECT FOR ENGINE COOLANT LEAK . (See ON-VEHICLE INSPECTION ). )
INSTALL V-BANK COVER . (See INSTALLATION ).
INSTALL FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY . (See INSTALLATION ).
INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY
1. Install the front wiper motor and link assembly. (See INSTALLATION ).
INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )