Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2008 >> Tacoma Base, 2D Pickup, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System (1GR-FE)) >> VVT Sensor >> Removal

VVT Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  3. REMOVE V-BANK COVER  (See REMOVAL  )
  4. REMOVE AIR CLEANER ASSEMBLY  (See REMOVAL  )
  5. REMOVE VVT SENSOR 
    1. RH bank side VVT sensor:
      1. Disconnect the VVT sensor connector.
        2. Fig 1: Locating VVT Sensor Connector
        G05676929Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the bolt and VVT sensor.
    2. LH bank side VVT sensor:
      1. Disconnect the water by-pass hoses No. 4 and No. 5.
      2. Disconnect the VVT sensor connector.
        Fig 2: Locating VVT Sensor Connector
        G05676930Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Remove the bolt and VVT sensor.
scientia non olet · About Mike's Workshop Manuals