Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2008 >> Sequoia Platinum, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (3UR-FE) - Circuit Testing, Component On-Vehicle Inspection, Removal, Inspection & Installation >> Knock Sensor >> Inspection

Knock Sensor: Inspection

  1. INSPECT KNOCK SENSOR 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

      STANDARD RESISTANCE

      Tester Connection Condition Specified Condition
      1-2 20°C (68°F) 120 to 280 kΩ

      If the result is not as specified, replace the knock sensor.

      Fig 1: Measuring Resistance Of Knock Sensor
      G05644787Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals