Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2008 >> Sequoia Platinum, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (3UR-FE) - Circuit Testing, Component On-Vehicle Inspection, Removal, Inspection & Installation >> Engine Coolant Temperature Sensor >> Installation

Engine Coolant Temperature Sensor: Installation

  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket to the sensor.
    2. Using a 19mm deep socket wrench, install the sensor.

      Torque: 20 N*m (200 kgf*cm, 14 ft.*lbf) 

    3. Connect the sensor connector.
  2. ADD ENGINE COOLANT  (See REPLACEMENT )
  3. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  4. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
    Fig 1: Locating Engine Coolant Temperature Sensor Connector
    G05644784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals