Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2008 >> RAV4 Limited, 2.4 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Smart Key System (Keyless Start) (Diagnostics - Introduction)) >> Smart Key System (For Start Function) >> DTC Check / Clear >> DTC Check / Clear

DTC Check / Clear

WARNING: This page is about a different car, the 2010 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
    5. Check for DTCs.

      HINT: 

      Refer to the Techstream operator's manual for further details.

  2. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
    5. Clear the DTCs by following the directions on the Techstream display.

      HINT: 

      Refer to the Techstream operator's manual for further details.

scientia non olet · About Mike's Workshop Manuals