Inspection Procedure

1. Drive the vehicle and check that the function of the speedometer on the combination meter is normal.

   OK: Actual vehicle speed and the speed indicated on the speedometer are the same. 

NG:GO TO METER / GAUGE SYSTEM

OK: Go to Next Step 

1. Disconnect the E19 meter connector.
2. Disconnect the L13 (*1) amplifier or E49 (*2) receiver connector.
3. Measure the resistance of the wire harness side connectors.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition
   E19-39 (+S) - L13-11 (SPD) (*1)	Below 1 Ω
   E19-39 (+S) - E49-3 (SPD) (*2)	Below 1 Ω
   HINT: *1: for Premium sound models *2: for Standard models

Fig 1: Identifying E19 Meter Connector And L13 Amplifier Or E49 Receiver Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE