Inspection Procedure

HINT:

Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2. CHECK FOR OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR) 
   1. Disconnect the E47 center airbag sensor connector.
   2. Measure the resistance according to the value (s) in the table below.

      Standard Resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Switch Condition	Specified Condition
   E47-13 (CANH) - E47-22 (CANL)	Engine switch off	54 to 69 Ω

   NG: REPAIR OR REPLACE CENTER AIRBAG SENSOR BRANCH WIRE OR CONNECTOR (CANH, CANL) 

   Fig 1: Identifying E47 Center Airbag Sensor Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK: Go to Next Step 

3. CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR - BATTERY AND BODY GROUND) 
   1. Connect the cable to the negative (-) battery terminal.
   2. Disconnect the E47 center airbag sensor connector.
   3. Measure the resistance according to the value (s) in the table below.

      Standard Resistance 

      STANDARD RESISTANCE SPECIFICATION
      
      

      Tester Connection	Condition	Specified Condition
      E47-25 (E1) - Body ground	Always	Below 1 Ω
      E47-26 (E2) - Body ground

   4. Measure the voltage according to the value (s) in the table below.
   Fig 2: Identifying E47 Center Airbag Sensor Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Voltage 

   STANDARD VOLTAGE SPECIFICATION
   
   

   Tester Connection	Switch Condition	Specified Condition
   E47-21 (IG2) - Body ground	Engine switch on (IG)	11 to 14 V

   NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

   OK: REPLACE CENTER AIRBAG SENSOR ASSEMBLY  (See CENTER AIRBAG SENSOR ASSEMBLY )