Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

HINT:

DTC P2610 is set if an internal ECM (included in the hybrid vehicle control ECU) problem is detected. Diagnostic procedures are not required. ECM replacement is required.
Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

REPLACE HYBRID VEHICLE CONTROL ECU
1. Replace the hybrid vehicle control ECU (See REMOVAL ).
CHECK WHETHER DTC OUTPUT RECURS
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Clear the DTCs (See DTC CHECK / CLEAR ).
4. Start the engine and wait for 10 minutes or more.
5. On the Techstream, enter the following menu items: Powertrain / Engine and ECT / Trouble Codes.
6. If no pending DTC is displayed, the repair has been successfully completed.
NEXT: END