DTC C1380: Stop Light Control Relay Malfunction: Description
Upon receiving the downhill assist control (for 4WD) or hill-start assist control operating signal from the skid control ECU, the relay contact turns on and the stop light comes on.
DTC DETECTION CONDITION AND TROUBLE AREA TABLE
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1380 |
Either of the following is detected
- When the voltage at the IG1 terminal is between 10 and 14 V and the stop light control relay drive output (STPO) is ON, a signal has not been input to the STP terminal for 5 seconds or more
- When the voltage at the IG1 terminal is between 10 and 14 V and the stop light control relay drive output (STPO) is OFF, the signal at the STP is different from the input signal at the STP2 for 5 seconds or more.
|
- Stop light switch
- Stop light switch circuit
- Stop light control relay
- Stop light control relay circuit
- Brake actuator assembly (Skid control ECU)
|