Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When replacing the brake actuator assembly, perform zero point calibration (See CALIBRATION
).
- CHECK ABS CONTROL SYSTEM
- Clear the DTC (See DTC CHECK / CLEAR ).
- Turn the ignition switch to the ON position.
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
).
Result
RESULT CHARTCondition Proceed to DTC (ABS control system DTC) is not output A DTC (ABS control system DTC) is output B
B : REPAIR CIRCUIT INDICATED BY OUTPUT DTC (See DIAGNOSTIC TROUBLE CODE CHART )
A: Go to Next Step
- RECONFIRM DTC
- Turn the ignition switch off.
- Clear the DTC (See DTC CHECK / CLEAR ).
- Turn the ignition switch to the ON position.
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
).
Result
RESULT CHARTCondition Proceed to DTC (C1223/43) is not output A DTC (C1223/43) is output B
B : REPLACE BRAKE ACTUATOR ASSEMBLY
A : CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION)