Inspection Procedure

1. Clear the DTC (See DTC CHECK / CLEAR  ).
2. Turn the ignition switch to the ON position.
3. Check if the same DTC is recorded (See DTC CHECK / CLEAR  ).

   Result 

   RESULT CHART
   
   

   Condition	Proceed to
   DTC (ABS control system DTC) is not output	A
   DTC (ABS control system DTC) is output	B

B : REPAIR CIRCUIT INDICATED BY OUTPUT DTC  (See DIAGNOSTIC TROUBLE CODE CHART  )

A: Go to Next Step 

1. Turn the ignition switch off.
2. Clear the DTC (See DTC CHECK / CLEAR  ).
3. Turn the ignition switch to the ON position.
4. Check if the same DTC is recorded (See DTC CHECK / CLEAR  ).

   Result 

   RESULT CHART
   
   

   Condition	Proceed to
   DTC (C1223/43) is not output	A
   DTC (C1223/43) is output	B

B : REPLACE BRAKE ACTUATOR ASSEMBLY 

A : CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION)