Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2008 >> Camry Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System (Hybrid)) >> Initialization >> DTC U0001 High Speed CAN Communication Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0001) 
    1. Connect Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the tester on.
    4. Enter the following menus: Powertrain / Engine / Trouble Code.
    5. Read the DTCs.

    Result 

    RESULT CHART

    Display (DTC output) Proceed to
    U0001 A
    U0001 and other DTCs B

    B:  Go to DTC CHART 

    A: REPLACE HYBRID VEHICLE CONTROL ECU 

scientia non olet · About Mike's Workshop Manuals