Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2008 >> Camry Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System (Hybrid)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM  (See REPLACEMENT )
  2. DRAIN COOLANT (for Engine)  (See COOLANT (FOR ENGINE) )
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  4. REMOVE SERVICE PLUG GRIP  (See REMOVAL )
  5. REMOVE NO. 2 ENGINE ROOM SIDE LH COVER 
  6. REMOVE CONNECTOR COVER ASSEMBLY 
  7. CHECK TERMINAL VOLTAGE 
  8. INSTALL CONNECTOR COVER ASSEMBLY 
  9. INSTALL NO. 2 ENGINE ROOM SIDE LH COVER 
  10. REMOVE V-RIBBED BELT TENSIONER COVER SUB-ASSEMBLY  (See REMOVAL )
  11. REMOVE V-RIBBED BELT  (See REMOVAL )
  12. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY  (See REMOVAL )
  13. DISCONNECT RADIATOR HOSE OUTLET  (See REMOVAL )
  14. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE  (See REMOVAL )
  15. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE  (See REMOVAL )
  16. REMOVE ELECTRIC INVERTER COMPRESSOR  (See REMOVAL )
  17. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the connector clamp and wire harness clamp.
    3. Remove the wire harness clamp bracket from the wire harness.
    4. Remove the bolt, and then remove the crankshaft position sensor.
    Fig 1: Locating Crankshaft Position Sensor Bolt
    G05007995Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals