Stop Lamp Switch Check (With CVT)

WARNING: This page is about a different car, the 2007 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

CHECK STOP LAMP SWITCH INPUT SIGNAL

Turn ignition switch OFF.
Disconnect Intelligent Key unit connector.

Check voltage between Intelligent Key unit harness connector M52 terminal 26 and ground.

CONNECTOR TERMINAL VOLTAGE SPECIFICATIONS

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
M52	26	Ground	Brake pedal depressed	Battery voltage
M52	26	Ground	Brake pedal released	0

Fig 1: Checking Stop Lamp Switch Input Signal

OK or NG

OK >> Stop lamp switch is OK.

NG >> GO TO 2.

CHECK STOP LAMP SWITCH POWER SUPPLY CIRCUIT
1. Disconnect stop lamp switch connector.
2. Check voltage between stop lamp switch harness connector E13 terminal 1 and ground.
  1 - Ground: Battery voltage
OK or NG

OK >> GO TO 3.

NG >> Repair or replace harness between stop lamp switch power supply circuit and fuse.

Fig 2: Checking Stop Lamp Switch Power Supply Circuit

CHECK STOP LAMP SWITCH OPERATION

Check continuity between stop lamp switch terminals 1 and 2.

CONNECTOR TERMINAL CONTINUITY SPECIFICATIONS

Component	Condition	Continuity
Stop lamp switch	1	2	Brake pedal depressed	Yes
Stop lamp switch	1	2	Brake pedal not depressed	No

OK or NG

OK >> GO TO 4.

NG >> Replace stop lamp switch.

Fig 3: Checking Stop Lamp Switch Operation

CHECK STOP LAMP SWITCH CIRCUIT
1. Check continuity between Intelligent Key unit harness connector (A) M52 terminal 26 and stop lamp switch harness connector (B) E13 terminal 2.
  26 - 2: Continuity should exist.
2. Check continuity between Intelligent Key unit harness connector M52 terminal 26 and ground.
  26 - Ground: Continuity should not exist.
  
  Fig 4: Checking Stop Lamp Switch Circuit
OK or NG

OK >> Check condition of harness and connector.

NG >> Repair or replace harness.