Check CVT Device (Park Position Switch) Check

WARNING: This page is about a different car, the 2007 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CVT DEVICE (PARK POSITION SWITCH) INPUT SIGNAL

Turn ignition switch OFF.

While pressing the ignition knob switch, check voltage between Intelligent Key unit harness connector M52 terminal 10 and ground.

CONNECTOR TERMINAL VOLTAGE SPECIFICATIONS

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
M52	10	Ground	Selector lever is in "P" position	0
M52	10	Ground	Other than above	Battery voltage

OK or NG

OK >> Replace Intelligent Key unit. Refer to "REMOVAL AND INSTALLATION OF INTELLIGENT KEY UNIT ".

NG >> GO TO 2.

Fig 1: Checking CVT Device (Park Position Switch) Input Signal

CHECK CVT DEVICE (PARK POSITION SWITCH)

Disconnect CVT device (park position switch) connector.

Check continuity between CVT device (park position switch) terminals 6 and 8.

CONNECTOR TERMINAL CONTINUITY SPECIFICATIONS

Component	Terminals		Condition	Continuity
CVT device (park position switch)	6	8	Selector lever is in "P" position	Yes
CVT device (park position switch)	6	8	Other than above	No

OK or NG

OK >> GO TO 3.

NG >> Replace CVT device (park position switch).

Fig 2: Checking CVT Device (Park Position Switch)

CHECK PARK POSITION SWITCH GROUND CIRCUIT
Check continuity between CVT device (park position switch) harness connector M38 terminal 6 and ground.

6 - Ground: Continuity should exist.

Fig 3: Checking Park Position Switch Ground Circuit

OK or NG

OK >> GO TO 4.

NG >> Repair or replace harness.
CHECK PARK POSITION SWITCH CIRCUIT
1. Disconnect Intelligent Key unit connector.
2. Check continuity between Intelligent Key unit harness connector (A) M52 terminal 10 and CVT device (park position switch) harness connector (B) M38 terminal 8.
  10 - 8: Continuity should exist.
3. Check continuity between Intelligent Key unit harness connector (A) M52 terminal 10 and ground.
  10 - Ground: Continuity should not exist.
  
  Fig 4: Checking Park Position Switch Ground Circuit
OK or NG

OK >> GO TO 5.

NG >> Repair or replace harness.

CHECK INTELLIGENT KEY OUTPUT SIGNAL

Connect Intelligent Key unit connector and CVT device (park position switch) connector.

Check voltage between Intelligent Key unit connector M52 terminal 10 and ground.

CONNECTOR TERMINAL VOLTAGE SPECIFICATIONS

Connector	Terminal		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
M52	10	Ground	Selector lever is in "P" position	0
M52	10	Ground	Other than above	Battery voltage

OK or NG

OK >> CVT device (park position switch) circuit is OK.

NG >> Replace Intelligent Key unit. Refer to "REMOVAL AND INSTALLATION OF INTELLIGENT KEY UNIT ".

Fig 5: Checking CVT Device (Park Position Switch) Input Signal