Front Axle Hub: Reassembly

INSTALL FRONT AXLE HUB BEARING
1. Using SST and a press, insert a new hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.
  SST 09950-60020 (09951-00710), 09950-70010 (09951-07100)
  
  Fig 1: Identifying Hub Bearing And SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not remove the inner race because the hub bearing is built into the oil seal.
  - Do not use bearings that have been removed.
  - Do not wipe off any grease that has been applied to new bearings.
  - Do not bring magnets close to the magnetic rotor surface of the bearing.
  - Keep the magnetic rotor surface of the bearing free of foreign matter.
INSTALL FRONT DISC BRAKE DUST COVER
1. Provisionally install a new disc brake dust cover.
  
  Fig 2: Identifying New Disc Brake Dust Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a hammer, install the disc brake dust cover.
  SST 09223-56010
  NOTE:
  - Uniformly press in the disc brake dust cover while sliding SST slightly.
  - Surely press in the disc brake dust cover until the pressing-in base.
    
    Fig 3: Installing Disc Brake Dust Cover Using SST
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a chisel, fix the 3 points on the circumference.
  NOTE: Securely fold each end into the engagement grooves.
  
  Fig 4: Identifying Points On Circumference
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB SUB-ASSEMBLY
1. Using SST and a press, press the axle hub into the steering knuckle.
  SST 09608-32010, 09950-60010 (09951-00500), 09950-70010 (09951-07100)
  
  Fig 5: Pressing Axle Hub Into Steering Knuckle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB HOLE SNAP RING
1. Using snap ring pliers, install a new hole snap ring, as shown in Fig 6 .
  NOTE:
  - Do not overlap the end of the snap ring and the installation hole in the speed sensor on the knuckle side.
  - Do not damage the magnetic rotor surface of the bearing when installing the snap ring.
    
    Fig 6: Installing Front Axle Hub Hole Snap Ring
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002