Heated Oxygen Sensor: Installation

INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
1. Using SST, install the sensor.
  Torque:
  
  without SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  with SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (see PRECAUTION ).
  - Make sure SST and wrench are connected in a straight line.
    
    Fig 1: Removal/Installation Of Heated Oxygen Sensor (For Bank 1 Sensor 2)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
1. Using SST, install the sensor.
  Torque:
  
  without SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  with SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (see PRECAUTION ).
  - Make sure SST and wrench are connected in a straight line.
    
    Fig 2: Removal/Installation Of Heated Oxygen Sensor (For Bank 2 Sensor 2)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT EXHAUST PIPE ASSEMBLY (see INSTALLATION )
INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY (except Regular Cab Standard Deck) (see INSTALLATION )
INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck) (see INSTALLATION )
INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY (for Regular Cab Standard Deck) (see INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).