Camshaft Oil Control Valve: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE NO. 1 ENGINE UNDER COVER (See REMOVAL )
DRAIN ENGINE COOLANT (See REPLACEMENT )
REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
1. Remove the front wiper motor and link assembly (see REMOVAL ).
REMOVE FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY (See REMOVAL )
REMOVE V-BANK COVER (See REMOVAL )
REMOVE NO. 2 AIR CLEANER HOSE (See REMOVAL )
REMOVE AIR CLEANER ASSEMBLY WITH ELEMENT (See REMOVAL )
REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY (see REMOVAL )
REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1)
1. Disconnect the oil control valve connector.
2. Remove the bolt and oil control valve.
3. Remove the O-ring from the oil control valve.
  
  Fig 1: Locating Oil Control Valve Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2)
1. Disconnect the oil control valve connector.
2. Remove the bolt and oil control valve.
3. Remove the O-ring from the oil control valve.
  
  Fig 2: Locating Oil Control Valve Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002