Air Fuel Ratio Sensor: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY (for Regular Cab Standard Deck)
1. Remove the 4 bolts and 2 nuts.
2. Disconnect the exhaust pipe from the exhaust pipe support, and remove the 2 gaskets.
REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck)
1. Disconnect the air fuel ratio sensor connector.
2. Disconnect the heated oxygen sensor connector.
3. Remove the 3 nuts, exhaust pipe and gasket.
REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (except Regular Cab Standard Deck)
1. Disconnect the air fuel ratio sensor connector.
2. Disconnect the heated oxygen sensor connector.
3. Remove the 3 nuts, 2 bolts, exhaust pipe and gasket.
REMOVE FRONT EXHAUST PIPE ASSEMBLY
1. Disconnect the air fuel ratio sensor connector.
2. Disconnect the heated oxygen sensor connector and 2 clamps.
3. Remove the 2 bolts.
4. Remove the 3 nuts, exhaust pipe and 2 gaskets.
REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
1. Using SST, remove the sensor.
  SST 09224-00010
  
  Fig 1: Removal/Installation Of Air Fuel Ratio Sensor (For Bank 1 Sensor 1)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
1. Using SST, remove the sensor.
  SST 09224-00010
  
  Fig 2: Removal/Installation Of Air Fuel Ratio Sensor (For Bank 2 Sensor 1)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002