Inspection Procedure

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
3. Check the CRUISE main indicator light by performing the ACTIVE TEST.

   METER: 

   METER ACTIVE TEST LIST
   
   

   Tester Display	Test Part	Control Range
   CRUISE INDIC	CRUISE main indicator light	Indicator light BLINK / OFF

   OK: The indicator light blinks/goes off. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL )

OK: Go to Next Step 

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
3. Check the DATA LIST for proper functioning of the CRUISE main indicator light.

   ECM (Cruise control): 

   DATA LIST - ECM (CRUISE CONTROL)
   
   

   Tester Display	Measurement Item/Range	Normal Condition
   CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CRUISE" on OFF: "CRUISE" off
   CCS INDICATOR S	Cruise indicator signal (Sub CPU) / ON or OFF	ON: "CRUISE" on OFF: "CRUISE" off

   OK: When the cruise control main switch is operated, the display changes as shown above. 

NG: REPLACE ECM  (See REMOVAL )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )