Inspection Procedure

1. Connect the intelligent tester to the DLC3.
2. Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the CRUISE main indicator light blinks.

   METER: 

   METER - ACTIVE TEST LIST
   
   

   Tester Display	Test Part	Control Range
   CRUISE INDIC	"CRUISE" indicator light	BLINK /OFF

   OK: Indicator light blinks/goes off. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL )

OK: Go to next step. 

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to the ON position, and turn the intelligent tester main switch on.
3. Check the DATA LIST for proper functioning of the CRUISE main indicator light.

   ECM (Cruise control): 

   ECM (CRUISE CONTROL) - DATA LIST
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   CCS READY M	Cruise control system standby condition (Main CPU) / ON or OFF	Each time main switch is pushed, ON/OFF changes	"1"
   CCS READY S	Cruise control system standby condition (Sub CPU) / ON or OFF	Each time main switch is pushed, ON / OFF changes	"1"
   CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CRUISE" ON OFF: "CRUISE" OFF	"2"
   CCS INDICATOR S	Cruise indicator signal (Sub CPU) / ON or OFF	ON: "CRUISE" ON OFF: "CRUISE" OFF	"2"

   OK: When the cruise control main switch is operated, the display changes as shown above. 

   HINT:

   "1" is OK, but "2" is NG → DTC output or ECM failure

NG: REPLACE ECM  (See REMOVAL )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )