Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2007 >> Sequoia Limited, 4WD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Register Transmitter ID

Register Transmitter ID

  1. Set the tire pressure of all wheels (including spare tire) to pressure specified on the tire and loading information label.
  2. Connect the intelligent tester to DLC3.
  3. Turn ignition switch to ON position.
  4. Read and record the transmitter IDs (ID1 to ID5) by using the DATA LIST. See Fig 1 and Fig 2 .
  5. Select the "REGIST TIRE" mode.
  6. Select the "MAIN" registration mode.
  7. Input the transmitter IDs (ID1 to ID5) using the intelligent tester and transmit it to the tire pressure monitor ECU.
  8. Set the ID transmission condition to "SUCCEEDED" or "ID Registration is complete".
NOTE: If steps  4- 8 are not completed within 5 minutes, the mode will return to the normal operation mode.
Fig 1: Registering Transmitter ID Using Intelligent Tester (1 Of 2)
G00225414Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Registering Transmitter ID Using Intelligent Tester (2 Of 2)
G00225415Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals