Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2007 >> RAV4 Base, 2.4 D, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System (2GR-FE)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM  (see REPLACEMENT )
  2. DRAIN ENGINE COOLANT  (see REPLACEMENT )
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  4. REMOVE RADIATOR ASSEMBLY 
    1. Remove the radiator assembly (See REMOVAL ).
  5. REMOVE FAN AND GENERATOR V BELT  (see REMOVAL )
  6. DISCONNECT COMPRESSOR WITH PULLEY ASSEMBLY  (see REMOVAL )
  7. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
    Fig 1: Locating Crankshaft Position Sensor And Bolt
    G05184267Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals