Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2007 >> Matrix Base, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning >> COMPRESSOR AND MAGNETIC CLUTCH (for 1ZZ-FE) >> Reassembly

COMPRESSOR AND MAGNETIC CLUTCH (for 1ZZ-FE): Reassembly

  1. INSTALL MAGNETIC CLUTCH ASSEMBLY 
    1. Matching the parts shown in the illustration, install the magnetic clutch stator.
      Fig 1: Identifying Magnetic Clutch Stator
      G04966113Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a snap ring expander, install a new snap ring with the chamfered side facing up.
    3. Install the screw and connect the connector.
      Fig 2: Installing Snap Ring With Chamfered Side Facing Up
      G04966114Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing up.
    5. Install the magnetic clutch washer and magnetic clutch hub.
      NOTE: Do not change the combination of the magnetic clutch washers used before disassembly.
      Fig 3: Installing Magnetic Clutch Hub
      G04966100Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Using vise pliers, hold the magnetic clutch hub and install the bolt.

      Torque: 18 N*m (183 kgf*cm, 13 ft.*lbf) 

      Fig 4: Installing Bolt
      G05236283Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals