Brake Control Power Supply: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL BRAKE CONTROL POWER SUPPLY
1. Install the 2 brackets with the 4 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Locating Brackets And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the brake control power supply with the 2 nuts and bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 2: Locating Nuts, Bolt And Brake Control Power Supply
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the brake control power supply connector.
INSTALL DECK SIDE TRIM BOX LH (See INSTALLATION )
INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
INSTALL DECK BOARD NO.3 SUB-ASSEMBLY
INSTALL DECK BOARD NO.2 SUB-ASSEMBLY
INSTALL DECK FLOOR BOX REAR (See INSTALLATION )
INSTALL DECK FLOOR BOX FRONT (w/o Rear No. 2 Seat) (See INSTALLATION )
INSTALL DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat) (See REMOVAL )
INSTALL DECK BOARD SUB-ASSEMBLY (w/ Rear No. 2 Seat) (See INSTALLATION )
CHECK AND CLEAR DTC
(See DTC CHECK / CLEAR )