Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2007 >> Highlander Base, 2.4 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Lighting System) >> Lighting System >> Data List / Active Test

Data List / Active Test

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using the intelligent tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the power switch ON (IG).
    3. Read the DATA LIST according to the display on the tester.

      Main body ECU 

      MAIN BODY ECU DATA LIST

      Item Measurement Item / Display (Range) Normal Condition Diagnostic Note
      ACC SW ACC switch signal / ON or OFF ON: Power switch ON (ACC)
      OFF: Power switch OFF      		 -
      IG SW Ignition switch signal / ON or OFF ON: Power switch ON (IG)
      OFF: Power switch OFF      		 -
      D DOR CTY SW Driver's door courtesy switch signal / ON or OFF ON: Driver's door is open
      OFF: Driver's door is closed      		 -
      P DOR CTY SW Passenger's door courtesy switch signal / ON or OFF ON: Passenger's door is open
      OFF: Passenger's door is closed      		 -
      Rr DOR CTY SW Rear door courtesy switch signal / ON or OFF ON: Either right or left door is open
      OFF: Both right and left door are closed      		 -
      P LOCK POS SW Front passenger door lock position switch signal / ON or OFF ON: Front passenger door lock is in unlock position
      OFF: Front passenger door lock is in lock position      		 -
      DIMMER SW Headlight dimmer switch signal / ON or OFF ON: Headlight dimmer switch is in HIGH or FLASH position
      OFF: Headlight dimmer switch is in LOW position      		 -
      HIGH FLASHER SW Headlight dimmer switch signal / ON or OFF ON: Headlight dimmer switch is in FLASH position
      OFF: Headlight dimmer switch is in except FLASH position      		 -
      F FOG LIGHT Front fog light switch signal / ON or OFF ON: Front fog light switch is in ON position
      OFF: Front fog light switch is in OFF position      		 -
      AUTO LIGHT SW Auto light switch signal / ON or OFF ON: Light control switch is in AUTO position
      OFF: Light control switch is not in AUTO position      		 -
      HEAD LIGHT SW Headlight control switch signal / ON or OFF ON: Light control switch is in HEAD position
      OFF: Light control switch is not in HEAD position      		 -
      TAIL LIGHT SW Taillight switch signal / ON or OFF ON: Light control switch is in TAIL or HEAD position
      OFF: Light control switch is not in TAIL or HEAD position      		 -
      ILLUMINATE RATE Illuminate rate / ON or OFF Condition value will be displayed -
      D LOCK POS SW Driver's door lock position switch signal / ON or OFF ON: Driver's door lock is in unlock position
      OFF: Driver's door lock is in lock position      		 -
      LIGHTING TIME Lighting time / 7.5s, 15s or 30s Customized value will be displayed -
      I/L AUTO OFF Battery saver / ON or OFF Customized value will be displayed -
      I/L ON/ACC OFF Light the I/L when ACC OFF / ON or OFF Customized value will be displayed -
      I/L ON /UNLK Interior light ON W/Unlock / ON or OFF Customized value will be displayed -
      SENSITIVITY Turn on luminous intensity /
      DARK1, DARK2, NORMAL, LIGHT1, LIGHT2      		 Customized value will be displayed -
      DISP EX ON SEN Display extinction luminous intensity / DARK1, DARK2, NORMAL, LIGHT1, LIGHT2 Customized value will be displayed -
      DISP EX OFF SEN Display extinction release luminous intensity / DARK1, DARK2, NORMAL, LIGHT1, LIGHT2 Customized value will be displayed -
      DRL FUNCTION* DRL function / ON or OFF Customized value will be displayed -

      HINT:

      *: w/ Daytime running light

  2. PERFORM ACTIVE TEST 

    HINT:

    Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the power switch ON (IG).
    3. Perform the ACTIVE TEST according to the display on the tester.

      Main body ECU 

      MAIN BODY ECU ACTIVE TEST

      Item Test Details Diagnostic Note
      HAZARD Turn hazard light flasher relay ON / OFF -
      F FOG LIGHT Turn front fog light relay ON / OFF -
      HEAD LIGHT Turn headlight relay ON / OFF -
      HEAD LIGHT (HI) Turn headlight dimmer relay (headlight dimmer switch HIGH position) ON / OFF -
      TAIL LIGHT Turn taillight relay ON / OFF -
      DRL RELAY (Test Details)
      Turn daytime running light relay ON / OFF (Vehicle Condition)
      Power switch ON (IG), engine is stopped and light control switch is in OFF      		 -
      DIMMER SIG Turn dimmer relay ON / OFF -
      ILLUMI OUTPUT (Test Details)
      Turn daytime light and key illumination ON / OFF
      (Vehicle Condition) Doors are closed      		 -
scientia non olet · About Mike's Workshop Manuals