Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2007 >> FJ Cruiser 4WD, Part Time >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Park Assist/Monitoring >> Back Sonar Switch Assembly >> Installation

Back Sonar Switch Assembly: Installation

  1. INSTALL BACK SONAR SWITCH BULB CAP 
    1. Install the back sonar switch bulb cap.
      Fig 1: Identifying Back Sonar Switch Bulb Cap
      G05114221Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL BACK SONAR SWITCH BULB 
    1. Install the back sonar switch bulb.
      Fig 2: Identifying Back Sonar Switch Bulb
      G05114220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL BACK SONAR SWITCH ASSEMBLY 
    1. Engage the 2 claws and install the back sonar switch.
      Fig 3: Identifying Back Sonar Switch Claws
      G05114219Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL INSTRUMENT LOWER COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL FRONT CONSOLE BOX  (See INSTALLATION )
  6. INSTALL FRONT CONSOLE BOX BOTTOM MAT  (See INSTALLATION )
  7. INSTALL FRONT CONSOLE UPPER PANEL SUB-ASSEMBLY  (See INSTALLATION )
  8. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)  (See INSTALLATION )
  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

scientia non olet · About Mike's Workshop Manuals