Inspection Procedure

1. Disconnect the P11 regulator switch connector.
   Fig 1: Identifying P11 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the ignition switch ON.
3. Check the voltage between the terminal 4 of the wire harness side connector and the body ground.

   Standard voltage: 10 to 14 V 

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (SWITCH - RELAY) 

OK: GO TO NEXT STEP 

1. Remove the regulator switch.
2. Check the resistance between the switch terminals when the switch is operated, as shown in the table below.
   Fig 2: Identifying Power Window Regulator Switch (Rear RH) Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard resistance 

   POWER WINDOW REGULATOR SWITCH (REAR RH)
   
   

   Terminal No.	Regulator Switch	Specified Condition
   1-2, 3-4	UP	Continuity
   1 - 2, 4 - 5	OFF
   1 - 4, 3-5	DOWN

NG: REPLACE POWER WINDOW REGULATOR SWITCH (REAR RH) 

OK: GO TO NEXT STEP 

1. Disconnect the P15 motor connector.
2. Check the resistance between the wire harness side connectors.

   Standard resistance 

   SWITCH - MOTOR
   
   

   Terminal No.	Specified Condition
   P11-3 -P15-1	Continuity
   P11-1 -P15-2

   Fig 3: Identifying P11 And P15 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Check the resistance between the P11 regulator switch connector and body ground.

   Standard resistance 

   SWITCH - BODY GROUND
   
   

   Terminal No.	Specified Condition
   P11-1) - Body ground	No continuity
   P11-3) - Body ground

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: GO TO NEXT STEP 

1. Remove the motor.
2. Apply battery voltage to connector terminals 1 and 2.
3. Check that the motor smoothly rotates.
   Fig 4: Inspecting Power Window Regulator Motor Assembly RH (Rear RH)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard 

   POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (REAR RH)
   
   

   Terminal No.	Specified Condition
   Battery positive (+) → 1 Battery negative (-) → 2	Motor gear rotates counterclockwise
   Battery positive (+) → 2 Battery negative (-) → 1	Motor gear rotates clockwise

NG: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (REAR RH) 

OK: REPAIR OR REPLACE HARNESS AND CONNECTOR (MASTER SWITCH - SWITCH)