DTC P0705 Transmission Range Sensor Circuit Malfunction (PRNDL Input): Description
When the shift lever is in the N or P position: 1) the Park/Neutral Position (PNP) switch turns ON, and 2) ECM terminal NSW is grounded to the body ground via the starter relay and voltage becomes 0 V. When the shift lever is in the D, 2, L or R position: 1) the PNP switch turns OFF, and 2) ECM terminal NSW receives current and becomes the voltage of the ECM internal power source.
If the shift lever is moved from the N position to the D position, this signal is used for air-fuel ratio correction and for idle speed control (estimated control).
TRANSMISSION RANGE SENSOR CIRCUIT MALFUNCTION (PRNDL INPUT)
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0705 | 2 or more switches are ON simultaneously at P, R, N, D, 2 and L positions (2 trip detection logic) |
|
HINT:
After confirming DTC P0705, use the intelligent tester to confirm the PNP switch signal in the ALL menu (to reach the ALL menu: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL).