Inspection Procedure

HINT:

• DTC P2610 is set if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is required.
• Read freeze frame data using the intelligent tester or the OBD II scan tool. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

1. REPLACE ECM
2. CHECK WHETHER DTC OUTPUT RECURS
   1. Connect the intelligent tester to the DLC3.
   2. Turn the ignition switch to ON.
   3. Clear DTCs (See DTC CHECK / CLEAR ).
   4. Start the engine and wait for 10 minutes or more.
   5. On the tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / PENDING CODES.
   6. If no pending DTC is displayed, the repair has been successfully completed.

   END