Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2005 >> Prius >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (SFI) - Diagnostics >> DTC P2111, P2112: Throttle Actuator Control System- Stuck Open/Closed >> Inspection Procedure

Inspection Procedure

HINT:

Read freeze frame data using the hand-held tester or the OBD II scan tool. Freeze frame data records the engine condition when malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

  1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2111 AND/OR P2112) 
    1. Connect the hand-held tester or the OBD II scan tool to the DLC3.
    2. Turn the power switch ON (IG).
    3. Turn the hand-held tester or the OBD II scan tool ON.
    4. On the hand-held tester, select the item: DIAGNOSIS /ENHANCED OBD II/ DTC INFO / CURRENT CODES.
    5. Read DTCs using the hand-held tester or the OBD II scan tool.

      Result: 

      SCAN TOOL VALUES DESCRIPTION

      Display (DTC output) Proceed to
      P2111 or P2112 A
      P2111 or P2112, and other DTCs B

      HINT:

      If any other codes besides P2111 and/or P2112 are output, perform troubleshooting for those DTCs first.

    1. B: GO TO RELEVANT DTC CHART (See  DIAGNOSTIC TROUBLE CODE CHART   ) 
    2. A: GO TO NEXT STEP 
  2. INSPECT THROTTLE W/MOTOR BODY ASSY (VISUALLY CHECK THROTTLE VALVE) 
    1. Check for contamination between the throttle valve and the housing. If necessary, clean the throttle body. And check that the throttle valve moves smoothly.
    1. NG: REPLACE THROTTLE W/MOTOR BODY ASSY 
    2. OK: GO TO NEXT STEP 
  3. CHECK IF DTC OUTPUT RECURS (DTC P2111 AND/OR P2112) 
    1. Connect the hand-held tester or the OBD II scan tool to the DLC3.
    2. Turn the power switch ON (IG).
    3. Turn the hand-held tester or the OBD II scan tool ON.
    4. Clear the DTC.
    5. Put the engine in inspection mode (See PRECAUTION  ).
    6. Start the engine, and depress and release the accelerator pedal quickly (fully open and fully close).
    7. On the hand-held tester, select the item: DIAGNOSIS /ENHANCED OBD II /DTC INFO / CURRENT CODES.
    8. Start the engine, and depress and release the accelerator pedal quickly (fully open and fully close).
    9. Read DTCs using the hand-held tester or the OBD II scan tool.

      Result: 

      SCAN TOOL VALUES DESCRIPTION

      Display (DTC output) Proceed to
      No output A
      P2111 and/or P2112 B
    1. B: REPLACE ECM (See  ECM (1NZ-FXE)  ) 
    2. A: GO TO NEXT STEP 

      CHECK FOR INTERMITTENT PROBLEMS (See  CHECK FOR INTERMITTENT PROBLEMS   )