Inspection Procedure

1. See "INPUT SIGNAL CHECK " .
2. Check the indicator light operation when the clutch pedal is depressed.

OK: 

The indicator light goes off when depressing the clutch pedal. 

Fig 1: Identifying Indicator Light Blinking Pattern

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE   ) 
2. NG: GO TO NEXT STEP 

1. Disconnect the clutch switch connector.
2. Check that the continuity exists when the clutch switch assy is operated.

OK: 

Fig 2: Inspecting Clutch Switch

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. NG: REPLACE CLUTCH SWITCH ASSY 
2. OK: GO TO NEXT STEP

1. Check for open and short circuit in the harness and the connector between terminal D of ECM and the clutch switch (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
2. Check for open and short circuit in the harness and the connector between the clutch switch and the battery (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).

1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
2. OK: GO TO NEXT STEP. 

   CHECK AND REPLACE ECM