Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Tundra Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 477 (Body Control Systems - Diagnostics) >> Body Control System >> Circuit Inspection >> Theft Deterrent Indicator Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2006 Toyota Tundra and 2005 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

In case of using the hand-held tester, start the inspection from step  1 and in case of not using the hand-held tester, start from step  2.

  1. Check theft deterrent indicator using hand-held tester. 

    PREPARATION: 

    Connect the hand-held tester to the DLC3.

    CHECK: 

    Check that the theft deterrent in indicator comes on in ACTIVE TEST.

    1. OK: Proceed to next circuit inspection shown on  PROBLEM SYMPTOMS TABLE   . 
    2. NG: Go to next step 
  2. Check theft deterrent indicator (See  INSPECTION  ). 
    1. NG: Replace theft deterrent indicator. 
    2. OK: Go to next step 
  3. Check wire harness and connector between theft deterrent indicator and body ECU, and theft deterrent indicator and body ground (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG: Repair or replace wire harness and connector. 
    2. OK: Proceed to next circuit inspection shown on  PROBLEM SYMPTOMS TABLE   . 
scientia non olet · About Mike's Workshop Manuals