Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Sequoia Limited, RWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Systems - Diagnostics >> Circuit Inspection >> Taillight Relay Circuit >> Inspection Procedure

Inspection Procedure

  1. Check taillight relay (See  INSPECTION  ). 
    1. NG: Replace the taillight relay. 
    2. OK: Go to next step. 
  2. Check wire harness and connector between taillight relay and body ECU, battery and taillight relay (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG: Repair or replace wire harness or connector. 
    2. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
scientia non olet · About Mike's Workshop Manuals