Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Sequoia Limited, 4WD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Driver Door Control System - Diagnostics >> Circuit Inspection >> Window lock switch circuit >> Inspection Procedure

Inspection Procedure

  1. Check the window lock switch circuit using DTC check (See  HOW TO PROCEED WITH TROUBLESHOOTING  ). 
    1. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  or  PROBLEM SYMPTOMS TABLE   ). 
    2. NG: Go to next step. 
  2. Check wire harness and connector between driver door ECU and passenger door ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG: Repair or replace wire harness or connector. 
    2. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE   ). 
scientia non olet · About Mike's Workshop Manuals