Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (HVAC Systems (Manual) - Controls - Front) >> A/C Heater Control >> Installation

A/C Heater Control: Installation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Connect the two wire harness connectors to the heater-A/C control
  2. Position the heater-A/C control into the instrument panel.
  3. Install and tighten the three screws that secure the heater-A/C control to the instrument panel. Tighten the screws to 2 N.m (17 in. lbs.).
  4. Reconnect the battery negative cable.
scientia non olet · About Mike's Workshop Manuals