Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 950 (Wiper System & Washer System) >> Washer Fluid Level Switch >> Removal

Washer Fluid Level Switch: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open hood, disconnect and isolate the battery negative cable.
  2. Hoist vehicle.
  3. Turn the front of the left wheel inward.
  4. Loosen inner splash shield enough to gain access to the washer reservoir.
  5. Disconnect the electrical connector to the washer fluid level switch.
  6. Pull the washer fluid level switch from the reservoir (Figure).
    NOTE: Make sure to use a new grommet when installing a new switch, or even reinstalling the old switch back into the reservoir.
scientia non olet · About Mike's Workshop Manuals