Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Body Control Systems - Diagnostics) >> Circuit Inspection >> Theft deterrent indicator circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In case of using the TOYOTA hand-held tester, start the inspection from step 1 and in case of not using the TOYOTA hand-held tester, start from step 2.
  1. Check theft deterrent indicator using TOYOTA hand-held tester. 

    PREPARATION:

    Connect the TOYOTA hand-held tester to the DLC 3

    CHECK:

    Check that the theft deterrent in indicator comes on in ACTIVE TEST.

    1. OK : Proceed to next circuit inspection shown in PROBLEM SYMPTOMS TABLE   . 
    2. NG : Go To Next Step. 
  2. Check theft deterrent indicator (See  INSPECTION  ). 
    1. NG : Replace the theft deterrent indicator. 
    2. OK : Go To Next Step. 
  3. Check wire harness and connector between theft deterrent indicator and Body ECU, theft deterrent indicator and body ground (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG : Repair or replace wire harness or connector. 
    2. OK : Proceed to next circuit inspection shown in  PROBLEM SYMPTOMS TABLE  . 
scientia non olet · About Mike's Workshop Manuals