Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 360 (Abs - Diagnostics) >> System Tests >> TS Terminal Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check Voltage Between Terminals TS And CG Of DLC3. 

    Check  :

    1. Turn the ignition switch ON.
    2. Measure voltage between terminals TS and CG of DLC3.

    OK  : Voltage: 10-14 V.

    Fig 1: Locating DLC3 Terminals
    G01118848Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. OK  : If ABS warning light does not blink even after TS and CG have been connected, the ECU may be defective.
    2. NG  : Go to step  2.
  2. Check For Open And Short Circuit In Harness And Connector Between Skid Control ECU And DLC3, DLC3 And Body Ground. See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  . 
    1. NG  : Repair or replace harness or connector.
      2. NOTE: When replacing the ECU, perform the zero point calibration. See step  6 under PRE-CHECK.
    2. OK  : Check and replace skid control ECU.
scientia non olet · About Mike's Workshop Manuals