Rear Wheel Alignment (Ff): Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT TIRE (See INSPECTION )
MEASURE VEHICLE HEIGHT (See FRONT WHEEL ALIGNMENT (MAY, 2003) )
NOTE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
INSPECT TOE-IN

Fig 1: Inspecting Toe-In Measurement
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Toe-in:

USA, Canada:

Fig 2: Toe-In Chart (USA, Canada)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Mexico:

Fig 3: Toe-In Chart (Mexico)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the toe-in is not within the specified value, inspect and replace the suspension parts as necessary.
INSPECT CAMBER
1. Install the camber-caster-kingpin gauge or position vehicle on wheel alignment tester.
2. Inspect the camber.
Camber:

Fig 4: Camber Measurement Chart
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the measured value is not within the specified value, inspect the suspension parts for damage and/or wear and replace them if necessary become camber is not adjustable.