Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 601 (Lighting System - Diagnosis) >> Back-Up Light Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2002 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. DO ACTIVE TEST OF OBD II SCAN TOOL OR LEXUS HAND-HELD TESTER 
    1. Connect the LEXUS hand-held tester to the DLC3.
    2. Check the back-up light using ACTIVE TEST.

    Luggage Room J/B ECU: 

    LUGGAGE ROOM J/B ECU INSPECTION

    Description Tester display Check condition
    Back-up light BACK-UP LIGHT ON - OFF
    1. OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOM TABLE, SEE  PROBLEM SYMPTOMS TABLE  . 
    2. NG: GO TO NEXT STEP. 
  2. CHECK HARNESS AND CONNECTOR 
    1. Check for open and short circuit in harness and connector between luggage room J/B ECU and back up light.
    2. Check for open and short circuit in harness and connector between back up light and body ground.
    1. NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 
    2. OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOM TABLE, SEE  PROBLEM SYMPTOMS TABLE  . 
scientia non olet · About Mike's Workshop Manuals