Inspection Procedure

HINT:

Read freeze frame data using the hand-held tester or the OBD II scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. Are there any other codes (besides DTC P2119) being output? 
   1. YES : Go to relevant DTC chart (See  DIAGNOSTIC TROUBLE CODE CHART  ). 
   2. NO : Go to Next Step 
2. Replace ECM and Clear DTC (Check if DTC output recur). 

   PREPARATION: 

   1. Replace the ECM.
   2. Clear the DTC (See PRE-CHECK ).
   3. Start and warm up the engine.
   4. Run the engine at idle for 15 seconds or more.

   CHECK: 

   Read the DTC using the hand-held tester or the OBD II scan tool.

   OK: 

   1. Standard: No DTC output 
   1. OK : System is OK. 
   2. NG : Replace throttle body (See  REPLACEMENT  ).